We offer several additional components to expand and modify your system.
4 INCH GATE EXPANSION KIT W/ SENSOR
The STARTER KIT comes with three gates and sensors, BUT If you have more than three machines on your system, you can add as many additional gates as required. This kit includes one GATE, one SENSOR and one each SYSTEM CABLE and SENSOR CABLE.
4 INCH GATE EXPANSION KIT W/ MANUAL SWITCH
If you have a floor sweep or perhaps a chop saw where a sensor isn’t the right solution and would rather have manual control, we offer a kit which includes a GATE, MANUAL SWITCH and one each SYSTEM CABLE and SENSOR CABLE.
SENSOR SPLITTER KIT
NOTE: Gate not included.
The Splitter Kit affords you another degree of gate control, giving you two (or more) ways of controlling the Gate. The kit lets you have two Sensors, two Manual Switches or one each- Sensor and Manual Switch. The Splitter accepts three sensor cables- one each for a Sensor(s) or Manual Switch(s) and the Gate sensor input.
You can have as many Sensors and/or Manual Switches as you want controlling a single gate. Just add additional splitters. You will need N-1 Splitter Kits where N is the number of Sensors and Manual Switches you need. The splitters are daisy-chained together with the short cables that are included in each Splitter Kit. Just order the additional Sensor or Manual Switch Kits that you will need.
3 POLE MOTOR CONTACTOR
GG500A, GG500B and GG500C
The SYSTEM CONTROLLER included in the STARTER KIT supports single phase motors, either 115VAC up to 1HP or 230VAC up to 2HP.
The GG500A MOTOR CONTACTOR accessory supports larger single and 3 phase collector motors up to 5HP. The CONTACTOR has a 115VAC coil.
The GG500B MOTOR CONTACTOR includes a thermal protection module for 3 phase motors. The coil voltage is 115VAC.
The GG500C MOTOR CONTACTOR includes a thermal protection module for 3 phase motors. The coil voltage is 230VAC.
PARALLEL GATE KIT
Two 4 inch gates connected in parallel are the equivalent of a single 6 inch gate. Both gates open and close simultaneously to support larger ducted machines. The kit contains two 4 inch GATES, one PARALLEL GATE ADAPTER module, one SENSOR, one 6′ SENSOR CABLE, one 2′ GATE NETWORK CABLE and two 18″ SENSOR CABLES. 6 inch ducting is “wye’d” into the gates at both the inlet and outlet sides. Either a SENSOR or MANUAL SWITCH may be used. Although the kit includes a SENSOR, let us know your preference when ordering.
NOTE: Ducting is NOT included.